standard power integrated module flow 90pack1 features: flow90 pack 1 up to 600v/75a, 1200v/35a 3 ~ igb t inverter temperature sensor vincotech - power flow through for simple pcb routing vincotech - clip in the reliable interconnection between pcb, module and heatsink 600v trench fieldstop 1,2kv t rench f ieldstop dedicated for motor drive applications with a mechanic arrangement of 90 between heat-sink and pcb module types selection data: vincotech part number 600v trench-fieldstop 600v / 30a v23990-p704-f 600v / 50a v23990-p705-f 600v / 75a v23990-p706-f 1200v trench-fieldstop 1200v / 15a v23990-p708-f 1200v / 25a V23990-P709-F 1200v / 35a v23990-p700-f copyright by vincotech 1 revision: 1
v23990-p70x-a flow 90pack1 v23990-p70x-f-u-01-14 outline / pinout schematics copyright by vincotech 2 revision: 1
v23990-p70x-a flow 90pack1 v23990-p70x-f-u-01-14 handling instruction handling instructions... to the pcb the module must be fixed to the pcb by clipping into the adequate holes before pin soldering. see below after fixing all pins must be soldered into the pcb. during assembly, at a max. module temperature of 25c, the pins should not be drawn or pushed more than 0.2 mm or loaded with a higher force than 35n. at a maximum substrate-temperature of 100c the load of the pin should not exceed 5n. vibration stress on pins is not allowed ...to the heat sink the heat sink surface must be clean and particle less. the flatness must be < 0.05 mm for 100 mm continuous. the surface roughness should be less than r z = 0.01 mm. ...to the thermal paste homogenous applying of the thermal conducting paste over the whole module plate with a thickness of max. 0.05 mm. thicker thermal paste can raise the value of the r th . ...to the fastening screws to the heat sink if plain washer is used and optional with a spring lock washer important parameter screw m4 din 7985 flat washer din 125 or din 433 spring washer din 127 or din 128 mounting torque m a =2.0-2.2nm copyright by vincotech 3 revision: 1
|
